Reply To: How to output monitor before adding to mix on FarPlay?

Keymaster

Dear Morgan,

Thank you for your helpful clarifications.

If you have an audio interface with advanced routing/loopback capabilities, you can do the following (this method doesn’t use BlackHole).

Tell Logic to use your audio interface as its output device. In Logic’s mixer, send your loops to outputs 5 and 6 and send your software instrument audio to outputs 7 and 8.
In your audio interface’s mixing/routing software, send the audio on outputs 5, 6, 7, and 8 to your headphones mix and, at first, send only the audio on outputs 5 and 6 to the mix for the virtual input that you choose as the microphone in FarPlay.
When you’re happy with how your software instrument sounds, use your audio interface’s software to send audio from outputs 7 and 8 to the mix for the virtual input FarPlay is using as its microphone.

Thank you,
David Liao